Thunder Beast 5.56 Takedown Direct Thread Suppressor - Black Review

About Thunder Beast 5.56 Takedown Direct Thread Suppressor - Black

Heavy-duty 5.56 Suppressor Made specifically for .223/5.56 SBR’s and “one-stamp” uppers AVAILABLE IN EARLY JANUARY 2018 The 556 TAKE DOWN was designed around the 2017 USSOCOM Suppressor Upper Receiver Group (SURG) solicication. It may be used as direct thread, semi-permanently installed, permanently installed, or purchased as part of our DEDICATED SUPPRESSED UPPER. With a 10-inch barrel, the 556 TAKE DOWN was designed to meter at an average of 140 dB or less at both the mil-spec mic position and at the shooter’s ear with mil-spec Mk318 mod 0, Federal T556 TNB1, Hornady 5.56 75-grain Interlock HD SBR Black, or Hornady 5.56mm 75gr TAP SBR. (Actual suppression level will depend on ammunition and conditions.) This suppression level at the muzzle and at the shooter’s ear is made possible by specific tuning and baffle design, since a high level of muzzle suppression typically dramatically increases ejection port volume. An adjustable gas block is recommended to achieve this level of report at the shooter’s ear. The 556 TAKE DOWN can be fully disassembled by the end user. As a somewhat unusual design feature, the 556 TAKE DOWN is disassembled from its front, so that the suppressor may be disassembled while its body is still installed, permanently or otherwise, on an AR-15 upper receiver or rifle. It is designed to withstand at least 20,000 rounds before depot-level service comprising a firing schedule of 8 magazines fired rapid/burst/full-auto and then a cooling period. Although the suppressor has an indeterminate lifetime and will keep operating indefinitely, the baffles may be replaced by a depot-level service — for commercial customers, this is TBAC, the manufacturer — to regain the original suppression level. The baffles are salt bath nitride coated (melonite) to further extend their service lifetime. SPECIAL FEATURES Direct thread attachment option Nordlock (locking) washers included Toolkit and special tools available for purchase Rear wrench flats for installation/removal Pin hole on wrench flats for pinned/welded permanent installation Full disassemble-able from the front end, uses common tools Black nitride (melonite) coated baffles for longer service life 17-4 heat-treated stainless baffles, 316L tube When permanently pinned/welded to a 10″ upper, complete upper will no longer require a registered SBR host APPLICATION NOTES Minimum barrel lengths: 7″ 223 Rem, 5.56

Most Popular Suppressors

Daily Deals